Bottom Nailling Strip For Wood Siding Shingles

When nailing shingles proper penetration into the roof deck is essential to ensure the nail and shingle remain secure.

Bottom nailling strip for wood siding shingles.

Starter strip should be 4 5 in. From the bottom edge of the starter strip. Thick and installed to hang below shim approximately 1 in. Wood siding shingles and shakes.

Siding nail face nailing face nailing is applicable where dictated by building code in high wind areas and when fastening is to osb or equivalent sheathing without penetrating into studs. Sheathed wall starter strip starts shingles at the proper angle. Install the kickout flashing underneath the first shingle photo 1. Add felt if needed before nailing the new wood on and prime the new wood on all four sides before installing it.

The indentations profile cut outs of the bottom edge of the first course of siding must overlap. Install horizontal wood cedar strapping to the shed frame with screws higher up the shingle. Adapted paraphrased with permission from best practices guide to residential construction. The recommended exposure varies depending on the size height of the shingles.

If the shingle already has flashing on it the kickout flashing has to slip beneath it and you ll have to loosen or remove siding to do this. Attach shingles to the strapping one row at a time jogging the placement so one is higher and the next lower etc. Apply siding to wall assembly directly to wood structural panel sheathing. Stop the siding where you wish the shingles to start.

Patented surenail technology features a wide highly visible engineered fabric strip in the nailing area for a consistent quality installation and the unique product design provides. For all owens corning shingles roofing nails should penetrate into the wood deck by a minimum of inch or completely through the roof deck by a minimum of 1 8 inch. The difference between a good shingle and a great shingle is having surenail technology only available from owens corning on duration series shingles. Starting from left to right level and install the siding so the bottom edge is no more than 1 2 inch below the starter strip.

Begin by nailing a starter strip approximately 3 8 inch thick x 1 1 2 inch wide flush with bottom edge of sill plate. If desired the starter strip can be cut from the top of the siding and the bottom portion used for the top course. But i used cedar strips for strapping and screws to install the shingles. Click to enlarge any image this article series discussion includes wood shingle siding underlayment requirements.